Industrial Half-Slim


Phison’s Half Slim SSD delivers all the advantages of flash disk technology with Serial ATA III interface, and one PCB design is fully compliant with the standard Half Slim form factor based on JEDEC MO-297 standard, and another one is fully compliant with standard 2.5-inch form factor which designed based on the standard 7-pin interface for data segment and 15-pin for power segment. This module provides low power consumption compared to traditional hard drive and hot-swapping when removing/ replacing/ upgrading flash disks, as well as operating at a maximum operating frequency of 300MHz with 40MHz external crystal. Its capacity could provide a wide range up to 64GB for SLC Flash solution. Moreover, it can reach up to 500MB/s read as well as 140MB/s write high performance based on Toshiba’s 32nm/24nm Toggle SLC flash.

Product Specification










SATA 2.0

 SATA 3.0

 SATA 3.0

 Flash Memory


 Performance (Note1)

Read: up to 190 MB/s
Write: up to 185 MB/s

 Read: up to 520 MB/s
Write: up to 130 MB/s

 Read: up to 510 MB/s
Write: up to 190 MB/s

 Power Consumption (Note1)

 Active mode:< 1,550 mW

 Active mode: < 3,100 mW  Active mode: < 2,000 mW

 General Applications

Storage, Recording, Back up, Boot device, Database in Server, NAS, SAN, Surveillance, Industrial PC/machines

 Operating Voltage

 DC 5.0V

 Operating Temperature

 0°C ~ 70°C (Silver)
-40°C ~ 85°C (Diamond)

 Reliability (Note2)

IEC-60068, IEC-61000, MIL-STD-810, ISTA 2 Series


More than 1,000,000 hours

 More than 2,000,000 hours


Products are tested with both operational and non-operational status to ensure the highest qualities.


DEVSLP mode, Static/Dynamic Wear leveling, Error Correcction Code (ECC),Power Loss Protection, SMART Function, TRIM, Over-Provision, pSLC support, Conformal Coating, Secure Erase


 beta HS-SSD easy DS_v30.pdf

Note 1: Performance and Power Consumption may differ according to flash type, flash configuration, and platform.

Note 2: All reliability tests follow international standards

Search using keywords: